Grasshopper

algorithmic modeling for Rhino

creating surface that connects two existing surfaces

Hey,

 

I'm trying to create a surface/mesh between two existing surfaces in space (lying on a same plane).

Idealy, I would want to select two points from each surface and create the third surface using those 4 points. How would I do this? Or is there another way to create this third surface?

Views: 1217

Replies to This Discussion

Permalink Reply by Michael Pryor on August 8, 2011 at 2:59pm

cull out the 2 points from each surface, then use surface 4 point

 

Permalink Reply by Niko Hur on August 9, 2011 at 12:37am

Hey Michael,

how exactly do you cull out the 2 points???

Permalink Reply by Michael Pryor on August 9, 2011 at 5:45am
Use cull index. Type the number of the point you want and input it into cull index. 2 points for each surface. So two culls pur surface. then use those points for a new surface.
Permalink Reply by Pieter Segeren on August 8, 2011 at 3:18pm
Hi Niko, I tried something that just might work on your surfaces as well. If not, it might lead to sth else:) Might be a bit over-engineered. Still, hope this helps.
Attachments:

RSS

About


McNeel Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2026   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service