Grasshopper

algorithmic modeling for Rhino

cannot bake gemoetry - fillet issue

Hi

I have an odd issue I cannot resolve.
As you an see the red revolve does not render with the openGL shader
as well as not bake into actually NURBS geometry.
And I am not sure why this is an issue. I drew all lines following the same
direction. 

The fillet curve tool creates something bad here.
If I remove it it works fine.

But than it works fine with the fillet node on the inner part of the ring.

Views: 564

Replies to This Discussion

Permalink Reply by Frederik on January 2, 2013 at 12:47am

Hi,

I had the same issue. When using Fillet on a joined Line/Arc and then do a RevSrf the geometry is not baking into Rhino. Seems to be a bug in Grasshopper.

Workaround is to add a Rebuild Curve after the fillet and before RevSrf. Then it works again.

Frederik

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service