Grasshopper

algorithmic modeling for Rhino

Daniel Piker's Discussions (1,808)

Search Forum

View

Discussions Replied To (1017) Replies Latest Activity

"To pull the edge of a mesh onto some curve, you need to extract the naked edge verti…"

Daniel Piker replied Jul 25, 2012 to Mesh Division

 18 Jun 14, 2017
Reply by Gilang Arenza

"Hi Ton, Automatically generating a nice all quad mesh of an arbitrary surface is ac…"

Daniel Piker replied Jul 25, 2012 to Mesh Division

 18 Jun 14, 2017
Reply by Gilang Arenza

"You could also maybe try using the 'Shell and plate' example from this page. It can…"

Daniel Piker replied Jul 22, 2012 to Pepakura, unrolling a mesh

 9 Jul 23, 2014
Reply by Martin Siegrist

"I'm not really sure how one would define a minimal surface from 4 points only withou…"

Daniel Piker replied Jul 20, 2012 to What kind of surface do I get from "4 point surface"???

 13 Jul 20, 2012
Reply by Peter Stavnshøj

"Hi Chris, The way I would recommend to do this would be to actually use 2 springs fo…"

Daniel Piker replied Jul 9, 2012 to Restricting the max and min length of a spring

 4 Jul 10, 2012
Reply by Chris Tron

"The algorithm described in section 2.3 of this paper: http://www.win.tue.nl/~vanwijk…"

Daniel Piker replied Jul 5, 2012 to Seifert surface

 11 Jul 6, 2012
Reply by cornucopio

"I would also recommend to input lines (rather than meshes*) to the Geometry Input of…"

Daniel Piker replied Jun 13, 2012 to Is it possible to compare a mesh before and after Kangaroo??... (explanation inside)

 10 Nov 14, 2012
Reply by Christophe Barlieb

"try looking in these 2 long discussion threads: http://www.grasshopper3d.com/forum/t…"

Daniel Piker replied Jun 12, 2012 to in search of the organic

 3 Jun 19, 2012
Reply by juamorle

"Hi Tim, Good question, and something I have been meaning to address for a while. Net…"

Daniel Piker replied Jun 11, 2012 to Analyze fabric with customized springs

 6 Jun 13, 2012
Reply by TimFLM

"Hi Oliver, Repulsion might work with a greater negative exponent ( eg -2 or -3), be…"

Daniel Piker replied Jun 7, 2012 to Distribute points along curves - CurvePull on open curves

 2 Jun 7, 2012
Reply by Oliver David

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service