algorithmic modeling for Rhino

Forum Discussions (33,608)

Sort by: View

Discussions	Replies	Latest Activity
How to find the Centerline of a wall Hi Guys, I can figure out a way to find the centerline of a wall when the wall is a continuous polyline, but in many cases the outlines of… Started by jackieyin in VB, C# and Python Coding	0	Aug 8, 2016
Kangaroo will not launch So I have just a quick question. I dragged and dropped the add-on Kangaroo multiple times and deleted it multiple times in Grasshopper. I h… Started by Andrew T. in Discussion	3	Aug 8, 2016 Reply by dude
Geodesic Dome tile Hello, how are you guys? im new at rhino and also grasshopper, i write here because i want to find the way to solve my project as i expect.… Started by jesus sanchez in Discussion	0	Aug 8, 2016
Getting Meshes and Surfaces from Thickened Simple Curves Hi.I am trying to get into getting surfaces/meshes from simple curves (to build typography and rings). Unfortunately this is very frustrati… Started by Marcus Strube in Discussion	4	Aug 8, 2016 Reply by Marcus Strube
selecting list pattern hi all, i have a flattened list from 0 to 24. with partition list i've created a list: 0, 1, 2, 3, 4 5, 6, 7, 8, 9 and so on until 24 i ne… Started by roy orengo in Discussion	8	Aug 8, 2016 Reply by Marcus Strube
About intersections of geometry (cylinders) I made the lines with using Voronoi and cylinder. I would like to make it as a solid or mesh like the picture at the very bottom. (I guess… Started by SSB in Discussion	3	Aug 8, 2016 Reply by Chapulin Colorado
Divide GUID list into sublists with out without DataTree Hi, I still cannot figure out how to divide a list in python. Sure I could just split it in GH, but that's not what I am after. I have… Started by johnnyUtah05 in VB, C# and Python Coding	6	Aug 8, 2016 Reply by Paul Poinet
how to make a surface from 2 intersection curve? i want to creat a surface(red line),from 2 polyline curve.but donnot know how to do it. thankyou! Started by Andrea Lu in Discussion	2	Aug 8, 2016 Reply by Andrea Lu
Connect diagonally a grid of points Hi, super basic question for a super basic GH user!!! I have a square of points created with "series" and I would like to connect them diag… Started by Federico Landi in Discussion	6	Aug 8, 2016 Reply by Joseph Oster
C# type and variable problem Hello, I am a beginner of C# in grasshopper and I have a problem with writing code in custom additional code in grasshopper. Here is my cod… Started by light in VB, C# and Python Coding	3	Aug 8, 2016 Reply by Long Nguyen