algorithmic modeling for Rhino

Forum Discussions (33,608)

Sort by: View

Discussions	Replies	Latest Activity
voronoi nodes data structure HiI'm having some troubles with managing the data structure of a 2d voronoi pattern that i want to extrude and layout flat for laser fabric… Started by Aron Fidjeland in Discussion	0	Apr 29, 2010
tensegrity 4 way grid Hello all, has anyone dealt with tensegrity 4 way grids? Many thanks Started by Lida Sklirou in Discussion	7	Apr 29, 2010 Reply by Lida Sklirou
curve line intersection module not working properly? Hi, I'm new here, but working with grasshopper since already quite some time.Since I've finally downloaded the new grasshopper definition (… Started by stefan naumann in Discussion	2	Apr 29, 2010 Reply by stefan naumann
How to generate a family of curve based on the given one? I have a symmetrical curve on the plane, what I want to do is to generate a family of this curve based on keeping the same length of black… Started by Shuyang.Mi in Discussion	1	Apr 29, 2010 Reply by David Rutten
Formation Hello, I'm from Oporto, Portugal and i would like to make a formation in Grasshopper. Does any one know if there will be a formation in P… Started by antonio jose da cunha carvalho in Discussion	4	Apr 29, 2010 Reply by Carlos Pérez
Data Tree Consistency Hi David is the change in the data tree of the Offset component's output parameter by design? See attached Started by Tuan N. Tran in Discussion	4	Apr 29, 2010 Reply by taz
aggregate hi, i was wondering if anyone knew how to generate a system of aggregate and to make it follow a curve? thanks in advancejames Started by james madden in Discussion	1	Apr 29, 2010 Reply by P. Casey Mahon
Autodesk's world domination Hi,A little bit disconcerting but I overheard a conversation earlier today, from someone who has a pretty close connection to Autodesk, tha… Started by Astro/Naught in Discussion	10	Apr 29, 2010 Reply by Jon Mirtschin
SOS how to make fin to its normal when i did it the right way? Hi all,I have a bunch of curves on a surface, and i have finned ( fin results are not to normal )them by using these steps,-intersecting cu… Started by Guan Xiong in Discussion	2	Apr 29, 2010 Reply by Guan Xiong
surface inclined from a surface I should build a surface inclined at X degrees from border or curve onsurface basis, is possible to do this construction with grasshopper? Started by omega69 in Discussion	0	Apr 29, 2010