Sign In

algorithmic modeling for Rhino

surface inclined from a surface

I should build a surface inclined at X degrees from border or curve on
surface basis, is possible to do this construction with grasshopper?

Views: 220

Attachments:

angled surface.jpg, 70 KB

About

Scott Davidson created this Ning Network.

Welcome to
Grasshopper

Translate

Search

Photos

Blob Mesh from Curves

by Parametric House 0 Comments 0 Likes

Roof Shell

by Parametric House 0 Comments 0 Likes

Floating Mobius Pavilion

by June Lee 0 Comments 0 Likes

Floating Mobius Pavilion

by June Lee 0 Comments 0 Likes

Floating Mobius Pavilion

by June Lee 0 Comments 0 Likes

Videos

Floating Mobius Pavilion Rhino Grasshopper Tutorial

Added by June Lee 0 Comments 0 Likes

Magnet Shade Pavilion Rhino Grasshopper Tutorial

Added by June Lee 0 Comments 0 Likes

Ngon Mesh

Added by Parametric House 1 Comment 0 Likes

Minimal Surface

Added by Parametric House 0 Comments 0 Likes

Wind Pavilion

Added by Parametric House 0 Comments 0 Likes

Mobius Cutout Pavilion Rhino Grasshopper Tutorial

Added by June Lee 0 Comments 0 Likes

© 2026 Created by Scott Davidson. Powered by

Badges | Report an Issue | Terms of Service

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use Grasshopper.

Please check your browser settings or contact your system administrator.