Grasshopper

algorithmic modeling for Rhino

spiral subdivide

Hi Grasshoppers,

im fairly new to grasshopper and searching some advice on the following problem:

im trying to subdivide a spiral in a constant way.
Just using a subdivide-node doesnt work for obvious reasons.
Points/columns on the outer side side are spaced further apart than toward the inside. (see pic2)
What i´d like to achive is constant subdivision like in pic3, or even better like pic4 (see next post).

Any ideas?

thanks in advance,
Jan

Views: 469

Attachments:

Replies to This Discussion

Permalink Reply by Jan Müntinga on December 17, 2009 at 11:46am
...and pic4
Attachments:
Permalink Reply by taz on December 17, 2009 at 11:51am
If I follow correctly what you're trying to do you could create lines from your hexagonal point grid and intersect those lines with your spiral surface.
Permalink Reply by Jan Müntinga on December 17, 2009 at 12:04pm
wow!

that was:

a) fast.
b) the right answer.

Many thanks taz!!!

Cheers!
Jan

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2026   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service