Grasshopper

algorithmic modeling for Rhino

Linear cut in mesh shell

Hello, is it possible in a shell to simulate a linear cut made from one point along the edge of the shell to a certain point in its interior (so not strictly a hole)? Thank you!

Views: 112

Replies to This Discussion

Permalink Reply by Karamba3D on June 22, 2019 at 3:53am

Hello Vale,

you can use Karamba3D's 'MeshBreps'-component and introduce the cut by first shattering the corresponding curve into small segments. Then feed their end-points into the 'IPts'-input of 'MeshBreps'. See the Karamba3D manual for details.

Best,

Clemens

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service