algorithmic modeling for Rhino
mesh loads
when I add a mesh load how is it measured? What is the default mesh load ? If I increase the load through an amplitude on the vector before the mesh load component it multiplies the load by this number, correct? Thanks
Views: 250
Replies to This Discussion
-
Permalink Reply by Karamba3D on
-
The physical unit to be supplied at the MeshLoad is kN/m2 in case of SI units (see manual; it's also mentioned in the comment which appears when you let the mouse pointer hover over the corresponding input-plug). There is no default value. The load is defined by the direction an length of the vector you feed into the 'Vec' input-plug.
Best,
Clemens
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
© 2024 Created by Scott Davidson.
Powered by
