Grasshopper

algorithmic modeling for Rhino

Hi! I've detected 2 cross sections in my assembled model I have not given to the model. Why does this happen? And, how can I know what section is using karamba to analyze my model? 
In the pic: first, I choose the cross section i'm interested in. Then, plug it into the model and detected that there were 3 cross sections. I disassemble the model to see that 3 sections and appear that two I've not choosen. Why does this happen?? Thanks!

Views: 608

Replies to This Discussion

These are the default cross sections is none are specified explicitly. one for beams, and one for shells. they are always the same, so you can easily recognize them.

if you disassemble a model, you can subsequently disassemble the beam elements - there it is written which cross section applies to every element.

best

R

so, in this case i've specified the frq 30/2 germany, why does that cross sections appear? Should appear only the cross section i've given for beams? Thanks R!!

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service