Grasshopper

algorithmic modeling for Rhino

Views: 535

Comment

You need to be a member of Grasshopper to add comments!

Comment by Ivan Kiryakov on July 15, 2012 at 9:55am
yes, I'm following that one
Comment by Brian Ringley on July 14, 2012 at 8:43am
Comment by Brian Ringley on July 10, 2012 at 11:27am

Ivan Kiryakov no offense taken - I value your input (that's why I made an account here). I think you bring up several valid points. Further to that, there are some parameters in this model that could be revisited relative to the fabrication process (3D powder printing). For example, some of the small mesh apertures became so small that the loose powder fused to the model - these apertures should have a minimum limit that prevents this from happening. Also, some of the interior cavities were too small or too deep to allow the vacuum tool inside, which meant that we had to excavate the part with the weight of the powder still inside - as you can imagine this caused breaks along some of the thinner spanning members of the topology. This could be avoided by enlarging or shortening some of these cavities, or simply by splitting the topology prior to the print and assembling it afterward.

Comment by Ivan Kiryakov on July 10, 2012 at 10:49am

Well mesh topology optimization , how the parts fit together,what the overall form has to say...all things you have to carefully consider before doing something like this (having in mind all the shared knowledge and components in this forum), I don't want to offend you and I also understand the work and the value behind this project,I looked at all the pics from the show and it looks like highly interesting stuff.

Just as a fellow kangaroo-weaverbird-grasshopper nerd I am not fully satisfied, thats all.

have a good day

Comment by Brian Ringley on July 9, 2012 at 3:38pm

This is a piece by Patrick Delorey. It's a minimal surface that was modeled in Grasshopper using Weaverbird.

@Ivan in what sense? Where would you take this concept, keeping in mind that in the end it must be able to be 3D printed in a ZCorp powder printer?

Comment by Ivan Kiryakov on July 9, 2012 at 3:16pm

this could have been so much better..

About

Translate

Search

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service