Hi, I'm reopening this thread cause all links seem broken at the original grillage fabrication.
I started with something more similar to gribs (cause they were close curves that define a volume, not a surface -a kind of rhino contour-). I would like to see one grasshopper file about Grillage Fabrication in order to improve my original one.
Thanks everyone. (I've added my file, if anyone is interested)
First off, thanks a lot for putting together and sharing the file! It is very intuitive and an incredible time saver.
I haven't had any problems using gFAB_v3.2 in the past, however, I'm encountering some bizarre issues this time around and was hoping you could shed some light on why I am possibly not getting good results
As you can see in the screen shot, some of the sections are not be properly generated and are causing there to be a failed intersection. What is particularly strange is that I get what seems to be unpredictable results if I change the parameters (spacing, height, etc.). There are also few other quirks such as tags not always being generated (especially for B sections) for every section laid out - but I'm not as concerned about that. I'm assuming this is an issue with the geometry I'm setting as the grillage object since no one else seems to be having this issue with the definition.