Grasshopper

algorithmic modeling for Rhino

surface split issue

I am trying to remove small circles from a component I have going all the way along my structure - I have completed the first set successfully, but I can't figure out why it's not worked on all components, even although they are derived from the same base surface. 

I have attached an image for clarity, as well as the file. Can anyone explain to me what's happening here? Many thanks in advance!

Views: 261

Attachments:

Replies to This Discussion

Permalink Reply by Jesus Galvez on November 21, 2013 at 9:40am

Hello Tash, 

that usually happens because the surfaces are not *exactly* in the same plane, so you have to use project. 

Permalink Reply by Jesus Galvez on November 21, 2013 at 9:41am

Here is the file. 

Attachments:
Permalink Reply by Tash Tash on November 23, 2013 at 5:29pm

Apologies for my late reply - thank you ever so much for your help!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service