surface or delaunay mesh from single closed overlapped 3D curve

Replies to This Discussion

Permalink Reply by David Rutten on September 8, 2010 at 2:12pm

Hi Paul,

instead of a single closed curve, could you supply only the outer two curves? I think if you have two parallel-ish polylines it wouldn't be that hard to try and triangulate your way down the middle.

--
David Rutten
david@mcneel.com
Poprad, Slovakia

Permalink Reply by paul hackett on September 9, 2010 at 6:23am

Yes, that would be a solution, but the problem comes when the region is not that parallel. Isn´t there a workflow for that situations?

Permalink Reply by David Rutten on September 9, 2010 at 6:33am

Oh my... this will be harder than I though. I need to digest this for a bit.

--
David Rutten
david@mcneel.com
Poprad, Slovakia

Permalink Reply by paul hackett on September 9, 2010 at 6:40am

ouch, sorry...me too, I am only hoping this would be possible.