Grasshopper

algorithmic modeling for Rhino

Using gHowl and TouchOSC to Calibrate Digital Tattoo Machine

Views: 228

Comment

You need to be a member of Grasshopper to add comments!

Comment by Vangel Kukov on July 20, 2013 at 1:26am

Fantastic! Great research!

Comment by Luke Gehron on July 16, 2013 at 3:47pm

I used the pen because it made it much easier to tell the pen to go back to that place when it draws the tattoo. I can tell the pen to move 3 cm closer to my arm when calibrating, and then when it is drawing on that point later it already knows to go exactly 3 cm. Using a proximity sensor I would have to accurately map that data to the pen servo motor.

Comment by Yasser Hafizs on July 16, 2013 at 3:41pm

why don't use proximity sensor? be careful man, don't try to make a hole in your hand

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service