Grasshopper

algorithmic modeling for Rhino

cap fail

Hi,

I loft a set of closed curves. I want to cap it so that i can trim a set of surface. when i cap the loft output, it failed to cap. I have no idea whatsoever. Can someone please guide me.
 

Best

Guan

Views: 1860

Replies to This Discussion

Permalink Reply by Tudor Cosmatu on May 23, 2010 at 4:16pm
Hi Guan,

are the border curves of the loft planar? If they re not, then that should be the reason.
Permalink Reply by Guan Xiong on May 24, 2010 at 5:30am
ahh yeah , its not aha didnt know that cap doesnt work for non planar ones. thank you!
Permalink Reply by babym on September 30, 2012 at 5:40pm

Hi! Im having the same problem with a non planar curve.. is there some sort of solution for this?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service