Grasshopper

algorithmic modeling for Rhino

split/trim curve beside intersect/region

dear all,

 

a simple question to split or trim curves.

 

as shown below, i create 2 diagonal-line which tangent the circle. Now I wanna trim the inside arc with these two diagonal-line.

I tried use trim/split it with region/brep. But thats means we need close all of curve as region.

In comparison to GH seems Rhino much easier by command 'trim'.

 

If anybody knows an elegant solution to trim curves like rhino command 'trim'?

 

GH loaded.

 

 

Views: 2659

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on July 5, 2012 at 8:46am

The trim command requires a mouse-pick to indicate what portion of a curve to remove. How would you like to provide that information in a Trim component?

If it's just circles and lines, why not create a new arc between the line end-points? Wouldn't that be an easier solution?

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Jon on July 6, 2012 at 9:38am

dear david,

 

thanks for tipps. I create a arc defined by center point, radius and angle domain. like below:

did u have any idea to set-up angel domain, so that the arc match to the 2 endpoints?

 

GH loaded.

 

 

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service