Grasshopper

algorithmic modeling for Rhino

how to creat a clean pipe like structure by joint lines for 3d print?

Hi all,

 

I have a structure model build in GH,only lines connect together, now I want to print it, but Im afriade of the machine not gonna make it if I just pipe the lines, so the question is, is there some ways to generate a pipe like model around those lines but without dirty joints for 3d printer?

 

Thnaks!

Views: 1554

Replies to This Discussion

Permalink Reply by taz on March 16, 2012 at 12:17pm

You could put a sphere at the nodes matching the diameter of your pipes (if they are all the same)

Permalink Reply by Taylor on March 16, 2012 at 1:45pm

thanks!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service