Grasshopper

algorithmic modeling for Rhino

Hello guys,

I just notice that in my file, I just cannot turn the joints between the cables and the two shells into hinges. I have checked the ID of the cables. They are correct. However, the joints are only rotatable in one direction. So they are not hinges so far.

Is there anyone who can help me with that?

Thanks very much!

Views: 317

Attachments:

Replies to This Discussion

After the first Kangaroo part, it should look like this.

Hi your current cable elements are defined as truss elements (defined with the orange circle) which means they are free to rotate in all directions and do not take bending moments. If you wish to have more control on these elements, you can use the BeamJoints component to control the specific joint itself.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service