algorithmic modeling for Rhino
Cantilever element
Hi
Could you help me please; I have a doubt about my modeling. I have element in aluminum recessed on one side and loaded on the other. I have a doubt about the supports because I used a divide to create supports, is that correct then I do not know how to integrate the thickness in my model. I have a doubt also about a load. Should i use a beam modeling or a shell?.
Views: 260
Replies to This Discussion
-
Permalink Reply by Karamba3D on
-
Hi Sandra,
make sure to select all points at the fixed support and not only some.
The thickness of the shell can be defined using a shell cross section definition (see manual).
In case of your open cross section it makes sense to use shell elements since the loads deform the cross section shape.
Best,
Clemens
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Scaling Tower
Added by Parametric House 0 Comments 0 Likes
-
Field Trap
Added by Parametric House 0 Comments 0 Likes
-
Subd Bridge
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
