Help with modeling

Replies to This Discussion

Permalink Reply by David Rutten on October 30, 2017 at 4:45pm

Do you need a single Nurbs surface? A patchwork of nurbs surfaces? Trims ok? Meshes ok?

Permalink Reply by M Sal on October 30, 2017 at 4:57pm

Meshes and trims should be ok but is there a way to make it a single Nurbs surface?

Permalink Reply by Michael Pryor on October 30, 2017 at 5:48pm

You asked a very similar question already to which you got some good answers.

Permalink Reply by M Sal on November 1, 2017 at 8:17am

Right, that inspired this post! What I gathered from that post was that a loft was not a good method to get the results I wanted. Do you have any suggestions for other methods to try