Grasshopper

algorithmic modeling for Rhino

Typing Manual Point Lists

Hi

Probably pretty basic but I am just trying to type in a list of points that I can then feed into a polyline component to draw something on the grasshopper side without using sliders et.al. I thought I could do it with a panel but I just get angry red..

Thanks

Views: 910

Replies to This Discussion

Permalink Reply by Michael Pryor on September 18, 2017 at 10:57pm

Use construct point and fill in the x,y,z's. Or reference points from rhino. Or type your points in the panel like this - 0,0,0 with multiline data on in panel settings. 

Permalink Reply by Julian Raxworthy on September 19, 2017 at 12:31am

Thanks Michael!

Used the panel, but weirdly it worked with multiline data off.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service