Grasshopper

algorithmic modeling for Rhino

establish a cocoon-form project by only one curve

Dear all,

Do you know how to establish a cocoon-form project by only one curve for simulating the spinning process of silkworms. Or if here is any plug-in to support.

Thanks a lot sincerely.

Views: 330

Replies to This Discussion

Permalink Reply by Laurent DELRIEU on November 12, 2016 at 2:26pm
you can look at that for curves
http://www.grasshopper3d.com/forum/topics/wrapping-winding-around-mesh
Search for winding filament wrapping ...
If you want to solidify use Cocoon plugins
Permalink Reply by Zoe on November 19, 2016 at 12:45pm

Thanks a lot! It's really helpful!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service