Gridded surface with holes in the surface

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on June 14, 2016 at 8:51am

This thread might be of some help.

Permalink Reply by Max Rind on June 16, 2016 at 11:59pm

Thanks a lot I almost solved the problem now.

On Problem is left.

I would like to put the grid in the air with cutting of all intersecting and gridlines that are in the upper mutiple breps.

But as you can see in the first picture there is missing a part of the intersecting upper(green ) grid and in picture two if the line is not intersecting the missing line is there but a second problem is occuring as seen in picture two, where a line doesn't get cut of right.

Could you please help me futher. Any help is much appreciated.

https://dl.dropboxusercontent.com/u/92424750/Workplace.3dm

https://dl.dropboxusercontent.com/u/92424750/Workspace.gh

Permalink Reply by Hyungsoo Kim on June 17, 2016 at 2:03am

Some sort of tolerence issue maybe?

Attachments:

• Workspace_re.gh, 10 KB

Permalink Reply by Max Rind on June 17, 2016 at 7:15am

Mmmh yes wow good idea. You just changed the factor right?

One thing is left when intersecting it still doesn't take a part of the curve.

I just don't understand why...mmHH. I guess now we are going in the very deep matter of grasshopper ("proud")  ;).

Attached the Rhino problem one more time. Thanks a lot for your help anyway.

https://dl.dropboxusercontent.com/u/92424750/Workplace.3dm

Permalink Reply by Hyungsoo Kim on June 17, 2016 at 7:51am

One of your box(bigger one) thouchs some grid lines instead of corssing them. Rhino and GH sometimes can't handle that kind of situation.

Attachments:

• Workspace_reV2.gh, 13 KB

Permalink Reply by Max Rind on June 22, 2016 at 4:32am

Thanks a lot for all the help I got it almost done through modifing, but it is still too inaccurate.

The grid inside the bottom rectangles of the brep need to fit perfectly into the breps shape and I need to be able to select the outer grid too. So I tried a different approach.

The first picture shows how the inner grid in the breps should look like(up in the air).

The intersecting points as shown in picture 2 are also right picked as you can see through the curve/curve panel.

I got it done with dispatch for just one brep, but the seperation of the inner and outer grid doesn't work with multiple breps. I'm pretty sure it is a small data tree problem, but I can't find the problem.

Could you please help me another time?

https://dl.dropboxusercontent.com/u/92424750/Workplace.3dm

https://dl.dropboxusercontent.com/u/92424750/outer%20and%20inner%20...

Permalink Reply by Hyungsoo Kim on June 22, 2016 at 6:47am

The matter is not as simple as you might think. Check attached.

Attachments:

• outer and inner grid2_re.gh, 25 KB

Permalink Reply by Max Rind on June 23, 2016 at 11:42pm

That's perfect. Thank you so much!