Grasshopper

algorithmic modeling for Rhino

recursive with Python using Honeybee

I posted the same problem on Grasshopper forum.

I am also asking here because I expect someone did the same this using Ladybug&Honeybee.

I am trying to the same thing as Andrei.

I would like to make recursion using Python and Honeybee.

But When I connect the output(feedback) of Honeybee to the input of Python,

as you know, it says "1. Recursive data stream found, this component depends on itself".

Any idea to solve this problem ?

Thank you.

Views: 347

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on May 12, 2016 at 5:58am

An easy solution is to write the value to a file and read it back.

Permalink Reply by Anton Szilasi on May 12, 2016 at 4:51pm

Using the grasshopper sticky could also be a solution

Permalink Reply by Yohei Kanzaki on May 12, 2016 at 10:20pm

To Anton

I didn't know that way.

Thank you.

Yohei

Permalink Reply by Yohei Kanzaki on May 13, 2016 at 3:44am

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service