Grasshopper

algorithmic modeling for Rhino

Offset Curve Tool

Hi All,

Is it possible to offset curves inwards in a way that allows for "islands". I.e. if there is a pinch-point, that a curve will split into 2, rather than just whichever has the largest area?

Thanks,

Laurens

Views: 639

Replies to This Discussion

Permalink Reply by Laurens on May 4, 2016 at 9:58am

Thanks a lot, Clipper worked brilliantly

Permalink Reply by Laurent DELRIEU on May 4, 2016 at 8:56am
Bowerbird plugin also use clipper and work very well
Permalink Reply by Laurens on May 4, 2016 at 9:58am

Bowerbird looks really useful, Clipper worked well enough this time

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service