Grasshopper

algorithmic modeling for Rhino

cluster not working ...

hey,

 

i dont get my cluster working. i connect everything ... then i cluster some components ... the cluster wont get any information from the outside the cluster components. the wires are connected to the cluster but their information wont reach the proper component inside. isnt it fixed yet or am i missing something?

 

thx!

Views: 982

Replies to This Discussion

Permalink Reply by Matt Gaydon on January 7, 2011 at 5:16am

See this discussion as you maybe having the same problem.

http://www.grasshopper3d.com/forum/topics/clusters-1

Permalink Reply by gised on January 7, 2011 at 1:43pm
that was it ... thx
Permalink Reply by David Stasiuk on January 7, 2011 at 5:34am

can you attached your definition?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service