assign a geometry in a range of a perpendicular frames

hi,

I'm new in grasshopper.

I'm trying to assign a geometry in a range of a curve I've before divided in n. parts with a perpendicular frame.

I can assign the geometry to the start and the end frame of the range but I can't assign the geometry inside the range.

Attachments:

geometry.3dm, 37 KB
geometry.gh, 8 KB

Replies to This Discussion

Permalink Reply by Joseph Oster on August 10, 2015 at 8:28am

What do you expect to get from passing 'Closed Breps' (your 'Geo' 'Oriented' by the 'PFrames') as inputs to 'Dom (Construct Domain)'?

Perhaps what you want to do is 'Shatter' a curve into segments and then divide only one segment with your 'PFrames'?

Permalink Reply by Joseph Oster on August 10, 2015 at 9:10am

Attachments:

geometry_20150810a.gh, 14 KB

Permalink Reply by luca rovero on August 10, 2015 at 9:22am

Thanks so much Joseph.

Permalink Reply by Pieter Segeren on August 11, 2015 at 7:17am

Use SubList:

Attachments:

SubList_PSG.gh, 24 KB

Permalink Reply by luca rovero on August 11, 2015 at 12:32pm

thanks a lot Pieter, your solution is much simpler than my initial and works exactly how I had imagined it.

I made some change to your.

I created two different geometries that workalternately.

Before I've tried to do it with Joseph solution but I had two problem: one was that when I changed the value's slider, sometimes some frames and geometries rotate 180 degrees. I solved it with "PFrame" and "Mirror"; the second, I didn't still solve, was that when I put the value's slider in zero each frame and geometry and worked without following any criteria.

Attachments: