Grasshopper

algorithmic modeling for Rhino

Views: 431

Comment

You need to be a member of Grasshopper to add comments!

Comment by MARIO VERGARA on June 5, 2014 at 1:49pm

well this is printed on a stratasys (powder) not plastic, so you don´t need support material

Comment by tibor on June 5, 2014 at 1:07pm

now i try similar, but my goal is to 3d-print severally each "node" with half-tentacle, because our 3d-printer is very expensive and would use too much support material...

Comment by MARIO VERGARA on June 5, 2014 at 12:12pm

that is correct tibor

Comment by tibor on June 5, 2014 at 9:24am

perhaps a skeletal mesh from a 3d voronoi diagram with thickness...?

Comment by Nezumi on June 5, 2014 at 7:06am

Hi~ realy impressive work. Is it a minisurf>.<?

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service