connection

Comment

Comment by Alessandro Zomparelli on February 16, 2010 at 9:30am

Thanks! Anyway, I used a bit Rhinoscript before to begin using Grasshopper.

Comment by Giulio Piacentino on February 16, 2010 at 9:23am

Wow one week. This is promising!

Comment by Alessandro Zomparelli on February 16, 2010 at 9:18am

I'm sure that this is possible, but I use Grasshopper only from one week... and I have not tried this cool tool yet :P

Comment by Giulio Piacentino on February 16, 2010 at 9:08am

Could you tell me if using WeaverBird would work for smoothing this cool mesh from within Rhino?

- Giulio

Comment by Alessandro Zomparelli on February 16, 2010 at 8:02am

You're...
I got the smooth effect of the holes exporting like a mesh in "blender". ;)
The original mesh looks like this:

Comment by Carlo Beltracchi on February 16, 2010 at 7:47am

Yeah, I agree with your "4 points" strategy.

Thanks

Comment by Alessandro Zomparelli on February 16, 2010 at 7:30am

There is no diffirence in the logic of method between nurbs and mesh. I tried at first with nurmbs, by creating an array of interpoladet curves, but then I prefer to work with surfaces for 4 pts (that are then converted in mesh).
It depends on what you need to do next.

Comment by Carlo Beltracchi on February 16, 2010 at 6:40am

I'm trying to understand your process!
Is the final result a mesh or a nurbs surface?

Comment by Ivo A. Semerdjiev on February 16, 2010 at 6:08am

thanks a lot

Comment by Alessandro Zomparelli on February 16, 2010 at 4:11am

I draw a rectangle that connect following points:
{0,0,0}
{0,1,0}
{1,1,0}
{1,0,0}

I worked in a 1x1x0 XYZ-space for creating my new pattern, later I use XYZ-cordinates of my new radial grid points for recreate the loft surface along the input-surfaces.
I used a 1x1x0 XYZspace, because using "reparameterize" on input-surfaces it gives to me a 1x1 UV-space

• ‹ Previous
• 1
• 2
• Next ›
• Page