Grasshopper

algorithmic modeling for Rhino

Autobake - duplicate results

  • I'm logging a interpolated curve behind your right hand using firefly/kinect
  • Then trying to lunchbox bake the result to rhino for storage, so that I can automate several steps in a process without overloading grasshopper.
  • I'm using the timer counter component from kangaroo as my trigger for the steps as I found that the fader/firefly conflicted with other components.

Does anyone know why lunch box bake would give me 46 baked curves rather than one?

Views: 842

Attachments:

Replies to This Discussion

Permalink Reply by Liam Dewhurst on May 14, 2013 at 10:14pm

Now using the delete duplicate curves and points tool - though if anyone has a better solution I would still be curious to know it?

Thanks,

Liam

Permalink Reply by Scott Mayson on May 18, 2013 at 4:17am
Maybe try slowing the timer down in firefly component.
Permalink Reply by Michael Makris on August 9, 2013 at 12:07am

Where is this option?

Permalink Reply by Liam Dewhurst on September 1, 2013 at 1:17am

hey mate, I didn't see your reply until now.

It's a kangaroo node, called remove duplicate lines.

And slowing the timer didn't seem to work, it's a glitch with large files where the solver bounces a few times before completing..

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service