algorithmic modeling for Rhino

Hello everyone,

I was trying to build the "shell" component using kangaroo 2 components so that I could use it easily with the new solver. I basically copied the algorism of the shell component in Kangaroo 1, only switching the "HingePoints", "HingeAngle" and "Hinge components. 

However, I could not get it work with Kangaroo 2 solver. The shell component seems not effective with low strength setting and becomes unstable with high strength setting.

Anyone have idea about what happens?

Thank you! 

Views: 198


Replies to This Discussion


The hinge component acts on pairs of triangles, so you need to triangulate your mesh first. You should also use the triangulated mesh for the edge lengths, because otherwise the quads are free to shear into diamond shapes.





© 2018   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service