Small request

Replies to This Discussion

Permalink Reply by phillip on April 19, 2013 at 1:33am

Totally agree.

Permalink Reply by Andrew Heumann on April 19, 2013 at 2:21am

but pull point doesn't only work with curves... do you want outputs for surface UV and mesh face/vertex as well? seems clunky since the output is dependent on the geometry type in question...

Permalink Reply by David Rutten on April 19, 2013 at 3:54am

Curve parameters are single numbers, Surface parameters are uv points (which can be represented by xyz points), Mesh parameters have their own data-type already and Brep parameters would be nothing more than a face-index+uv-point for which a data type could be made. I suppose having a generic output that will provide one of the above data types for each type of geometry would be reasonably clean.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by Michael Pryor on April 19, 2013 at 6:53am

Thanks for considering the possibility.

Permalink Reply by Michael Pryor on April 19, 2013 at 6:55am

Yea I know but if it can be clean I think its worth it. Or some component that is just for t values?