generative modeling for Rhino
I'm trying to figure out an exercise but I'm missing steps. The place where I'm learning it from is outdated so I can't find the functions described. I've been trying to figure it out on my own but I'm still too green with GH...
I'm basically trying to cut holes all over a surface, any surface, any shape.
Can you help me out with this definition?
hi Chris! thanks a lot...
would you mind writing the name of those functions involved? as I said, i'm taking my baby steps with GH, still don't know all the names :S
just a simple demand ,
how to make for obtain one Entrimmed Surf
rather than a Mesh ?
Like making in order to extract the perimetrals edge
of the Trimmed Surf , and use it , whit the circles ,
to generate a Entrimmed Surf-
Tanks in advanced
Hi Alberto, just skip the last mesh-component and you are left with a trimmed surface. Not sure, but I believe that Chris used it to get a nicer preview of the surface. Without it the surface looks a bit odd, but once you bake it you'll notice that it's perfectly fine.
I'am happy for feeling ... your voice
I have seen your post about the Interwoven Surf, truly of great interest, Compliments… but maybe this is a misunderstanding about that matter-
I asked if is possible to use a Planar Surf component,in order to obtain
a (Entrimmed Surf) rather a Brep or a Mesh-
Brep-Brep Components - Trimmed Surf - use the curves on Brep Components
to built a Surf-
and if yes like making -
(sorry for my bad english)
Here's the definition. The mesh component at the far right is just for appearances while viewing in Grasshopper as noted by Lars.
THanks a lot Chris and Lars!