Grasshopper

algorithmic modeling for Rhino

John Gulliford
  • Male
  • Bloomfield, NJ
  • United States
Share on Facebook
Share on Facebook MySpace
  • Blog Posts
  • Events
  • Groups (8)
  • Photos
  • Photo Albums
  • Videos

John Gulliford's Friends

  • André Bauer
  • Ben Howes
  • cesar
  • Matthew Naugle
  • David Mans
  • Gianni Giuffrida
  • Erick Katzenstein
  • Guy Snover
  • Jason Lim
  • Giulio Piacentino
  • Jacek Jaskólski
  • Nathan Miller
  • Luis Fraguada
  • Bob McNeel
  • Scott Davidson

John Gulliford's Groups

 

...

Comment Wall (1 comment)

You need to be a member of Grasshopper to add comments!

At 8:11am on January 5, 2013, André Bauer said…

Hi John,

had a look to the modified files, thanks for help and time first.

This is much easier already, very interesting.

But... :-) I the frames shall not be inbetween the both surfaces, they should be on top of the offset surface, as the the hull surface and the offset surface will build a volume together with the other surface on the hull layer.

As offset was impossible with joined surfaces, because they do not stop at Y=0 when offsetted,

I decided to offset each single surface, cut it and join them afterwards.

Also ther eare more parameters needed to define the number of frames (Anzahl Spantabstände) and the distance inbetween (Spantabstand). This was already working in my version so far.

The frame distance is a result of the waterline length divided by numbers of frames.

In my version I had just defined a length for the aft and forward position of the frames.

The frames shall extend to the hole boat, not only in waterline length.

And for last the upper and lower edge shall be aligned with the hull offset surface.

Sorry if all this was somehow missunderstable.

I hope now my target comes out better.

Think I have to check out, what exactly the components do, which you have used.

Hopefully I can get there then.

Thanks again.

How much time do need for an set up like yours?

How long and how often do you work with GH?

Best,

André

 
 
 

About

Translate

Search

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service