algorithmic modeling for Rhino
Could anybody explain the reason of the following strange behavior of the curve offset function:
Changing the numberf of the cutting planes the direction of some offsetted curves are in the opposit direction, like in the attached picture in case of using nr. 11 (means 9 cutting planes).
If I use nr. 14 than the result is as I have expected, but 15 is bad again, 16 is very strange.
It occures against I have tried to "directed" the section curves to the direction of the first section curve.
Thanks in advance!
Tags:
Plug the correct plane (in your case YZ) in the plane parameter of the offset component.
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by