algorithmic modeling for Rhino
This approach doesn't do edges, but if you need those you can always add some boundary points well outside your grid and well below the 0-level when you create the mesh.
I also don't pull the final polylines onto the points, the vertices are slightly off, as I intersect the mesh at an elevation of 0.9999. You can add that by getting the polyline vertices and pulling them all to the original point set.
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by