Grasshopper

algorithmic modeling for Rhino

Hardware "sliders" (knobs) for Grasshopper. Arduino board inside. See this post for more info: (http://www.grasshopper3d.com/photo/hardware-remote-control-in-gh). Firefly connects between arduino and GH. The grey plastic case is 14 x 11 cm.
Tomasz Gancarczyk made one too: http://www.grasshopper3d.com/photo/knob-controller
and so did bingg http://www.grasshopper3d.com/photo/arduino-in-use

Views: 517

Comment

You need to be a member of Grasshopper to add comments!

Comment by Mårten Nettelbladt on February 11, 2011 at 6:03am

Thanks guys. 

It's a mess inside, I can assure you. In fact all the wires turned out to be a perfect cushioning to the arduino board, I could barely sqeeze it all in and tighten the screws...

Comment by John Fredrickson on February 10, 2011 at 8:27pm
Nice! I like it w/ the exposed wiring better though...
Comment by Tuan N. Tran on February 10, 2011 at 6:31pm
nicely done marten.

About

Translate

Search

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service