algorithmic modeling for Rhino
Hardware remote control in GH
These 4 knobs are each connected to a 10 kohm potentiometer and then wired into an Arduino Uno board. Via USB cable into my computer where the Firefly component in GH reads the values. It works great and it's very fun to adjust a 3d model in this rather "direct" way...
Update: If you want to try this at home, please check out http://www.fireflyexperiments.com/ and download the Primer. You'll find almost everything explained in there. I ordered an Arduino Starter Kit from a Swedish site http://www.electrokit.se/moduler-mikroprocessor-arduino-starter-kit-mah-uno_12200001 and then I got some more potetiometers and some knobs.
I've put this in a case now, see here http://www.grasshopper3d.com/photo/hardware-remote-control-v2
Location: Stockholm
Comment
-
Comment by Matt Gaydon on February 1, 2011 at 1:37pm
-
Great Idea... I am guess you could attach other sensors as sliders too like, Pressue and Flex sensors to look a shaping and deformation forms...... Flex Sensor + Tapeworm Anyone :)
-
Comment by djordje on February 1, 2011 at 8:51am
-
great invention!
-
Comment by Mårten Nettelbladt on January 31, 2011 at 3:34pm
-
Ha ha, thanks!
-
Comment by Ivan Kiryakov on January 31, 2011 at 3:29pm
-
nice! tapeworm party! :D
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Scaling Tower
Added by Parametric House 0 Comments 0 Likes
-
Field Trap
Added by Parametric House 0 Comments 0 Likes
-
Subd Bridge
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
You need to be a member of Grasshopper to add comments!