Grasshopper

algorithmic modeling for Rhino

Loft not smooth

Hi,
forgive me if this a simple question... I'm just beginning with GH and when I create a Loft, I get a very angular result. It looks fine once it's baked in Rhino, but I wondered if this was normal or whether there was any way to get a smooth preview...?

I've seen one or two old posts asking the same thing, but I didn't notice any clear answer.

Thanks for any help


Views: 1210

Replies to This Discussion


McNeelPermalink Reply by David Rutten on July 13, 2010 at 11:58am
It's just the mesh that's rough, not the nurbs geometry. Grasshopper uses exceedingly coarse meshing parameters as it needs to mesh loads of geometry practically real-time.

The mesh is only used for preview/display purposes, it is not an indication of surface quality.

I'm planning mesh-quality overrides in future releases, but nothing is available yet that could change this.

--
David Rutten
david@mcneel.com
Poprad, Slovakia

RSS

About


McNeel Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2026   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service