Grasshopper

algorithmic modeling for Rhino

Good evening to everyone.

I would like to know if there is a command that allows me to extrude a mesh / surface compared to a grayscale or color.
Thank you for your attention.

Views: 723

Replies to This Discussion

Ciao Andrea,

Search the forum for the Image Sampler there are enough examples...the command extrude doesn't exist for mesh, but i can give you some custom codes that do enable this.

But first try to understand the image sampler and what it does and make an example where you explain a little bit what you wan't to achieve.

Cheers FF

This is a very simple example that works whit a mesh, I also think that you should look more about Image Sampler

http://www.grasshopper3d.com/forum/topics/surface-from-points-using...

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service