algorithmic modeling for Rhino
divide surf. doesn't produce enough points!
well, i used a SubSrf command on a surface and then try to extract corner points of each surface by divide surface and u,v=1,but only 2 points in each surface extracted!
i expect 4 points on a corners with this settings,which is worked on a single surface! whats the problem?
to be more clear of what has done ,i attached my definition
Views: 348
- Attachments:
-
-
why.gh, 2 KB
-
Replies to This Discussion
-
Permalink Reply by Andrew Heumann on
-
There has been a change in how the surface divide component works with data trees. It always organizes its results into U branches of V points. To get the data with one list of points per input surface, put a "shift paths" component after the surface divide with the default offset value of -1.
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
© 2025 Created by Scott Davidson.
Powered by
