Somebody know how to do Planar lips in grasshopper???

Replies to This Discussion

Permalink Reply by Danny Boyes on September 5, 2011 at 4:00am

It's not clear what you want to achieve. Which command from Paneling Tools do you want to recreate?

Or can you draw a sketch or model it in Rhino to give some visual clues?

Permalink Reply by Julian Oquendo on September 5, 2011 at 6:57pm

I need use PLANAR LIPS from paneling tools, but in grasshopper. Or something so similar, a definition that allows me to put my lips flattened surfaces.



Permalink Reply by Julian Oquendo on September 5, 2011 at 6:57pm

And thank you for answer me.

Permalink Reply by Danny Boyes on September 6, 2011 at 3:11am

Is this the sort of thing you are after?

If so then have a look at the attached definition.

Attachments:

• Lips.gh, 13 KB

Permalink Reply by Julian Oquendo on September 6, 2011 at 2:13pm

First thank you so much. That definition was that I was looking for...

 

Permalink Reply by Julian Oquendo on September 8, 2011 at 7:41am

Hey Danny, really thank you so much for your help. :D You'r nice