Grasshopper

algorithmic modeling for Rhino

multiple attractor points and curves in the same definition?

Hi guys, im trying to work out if its possible to use multiple (more than 2) attractor curves in my definition.  The definition uses the distance between an open curve and a closed curve to define the extrude height of the closed curve.  I was wondering if i can use more than two curves as the attractors and alos use points in the definition?  Any help would be much appreciated. Thanks guys! ive attached the definition

Views: 3334

Attachments:

Replies to This Discussion

Permalink Reply by Danny Boyes on May 1, 2011 at 7:52am

Hi Jesse,

 

Use the Pull Point Component in the Vectors Tab, Point Panel.

Permalink Reply by Jesse on May 2, 2011 at 2:57am
What a
Permalink Reply by Danny Boyes on May 2, 2011 at 3:55am

Is this fill in the blanks? I'll Have a go!

"What a...jolly nice chap you are." (Said with plum English accent) :)

of course I could be completely wrong and you intended the polar opposite.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service