Grasshopper

algorithmic modeling for Rhino

Hi,

I am trying to use the GeoProjection component to reference a set of points based on its Longitude and Latitude.

However, when I plug in the PRJ file, it is showing the error that missing projection parameter'latitude of origin'. 

The prj file is exported from GIS. It comes with the Shapefile. I am also tried to export it again. The error is still there.

Is there any way that I can get the correct prj file? In ArcGIS or In Grasshopper? I tried to manually add  PARAMETER["latitude_of_origin",0], then the component works but the point is not on the correct location, that it is not referencing to base map exported from GIS. 

Thanks in advance.

Views: 357

Attachments:

Replies to This Discussion

Tried the same to get it to work, but am note sure it's a proper placement. Would like to figure out what PRJ system mosquito is using, otherwise tough to use with other tools.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service