Grasshopper

algorithmic modeling for Rhino

Unroll surfaces that can be grouped

Hi Rajaa, I'm trying to unroll the square pyramids (see attached Rhino file) for laser cutting. Instead of unroll all of the pyramids and each pyramid in 4 triangles, I would like to them to be unrolled and grouped so that there will be every four triangles for each pyramid.

I did this in Grasshopper before. But I don't know if I can do the same using the paneling tool.

Thank you. Mei

Views: 477

Attachments:

Replies to This Discussion

Permalink Reply by Rajaa Issa on January 25, 2018 at 10:28am

Hi Jiangmei,

If I understood you right, here is what I'd do to keep each morph pyramid faces together. Before paneling, join panel faces of the module into one polysurface, then panel. After that when you use ptUnrollFaces, with Explode=No, you should be able to keep faces of each pyramid together.

Permalink Reply by Rajaa Issa on January 25, 2018 at 11:23am

Hi Jiangmei,

If I understood you right, here is what I'd do to keep each morph pyramid faces together. Before paneling, join panel faces of the module into one polysurface, then panel. After that when you use ptUnrollFaces, with Explode=No, you should be able to keep faces of each pyramid together.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service