Grasshopper

algorithmic modeling for Rhino

Rajaa Issa's Discussions (376)

Discussions Replied To (122) Replies Latest Activity

"That is not trivial. Your best best might be to find the center of the mesh face and…"

Rajaa Issa replied May 18 to project curve to mesh faces / 2D panel mesh

3 May 21
Reply by adimeyero

"Since it was already converted into diamond grid, it can be a bit challenging. I wou…"

Rajaa Issa replied Apr 11 to Diamond Problem

3 Apr 11
Reply by Rajaa Issa

"Hi Jiangmei, If I understood you right, here is what I'd do to keep each morph pyram…"

Rajaa Issa replied Jan 25 to Unroll surfaces that can be grouped

2 Jan 25
Reply by Rajaa Issa

"Hi Jiangmei, If I understood you right, here is what I'd do to keep each morph pyram…"

Rajaa Issa replied Jan 25 to Unroll surfaces that can be grouped

2 Jan 25
Reply by Rajaa Issa

"A couple of these steps will not be necessary. Here is how it can go: 1. Draw the li…"

Rajaa Issa replied Jan 15 to paneling on curve surface

8 Jan 15
Reply by Rajaa Issa

"Preston, I see in the example that the panels are tilted (their edges is not paralle…"

Rajaa Issa replied Jan 9 to paneling on curve surface

8 Jan 15
Reply by Rajaa Issa

"What is your tolerance? Do panels need to be fixed (with the dimensions you indicate…"

Rajaa Issa replied Jan 7 to paneling on curve surface

8 Jan 15
Reply by Rajaa Issa

"Here is a scree shot of the modified definition: "

Rajaa Issa replied Sep 12, 2017 to Radial Pattern

3 Sep 12, 2017
Reply by Rajaa Issa

"Hi Luke, Check the example I posted in discourse. It will give you some clues. Let m…"

Rajaa Issa replied Sep 12, 2017 to Radial Pattern

3 Sep 12, 2017
Reply by Rajaa Issa

"You just need to feed bounding surfaces to pull to. See attached file. "

Rajaa Issa replied Sep 7, 2017 to ptMorph3D - Pull tolerance

4 Sep 7, 2017
Reply by Michal Hol

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2018   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service