Grasshopper

algorithmic modeling for Rhino

Surface Split Problem.

Hello everyone.
I want to split this surface (revolved surface) with some curves.

But "SrfSplit" not only split my surface with the input curves, but also split it with one of the surface iso curves (the green curve in the below picture).


Here is the result of the "SrfSplit", I colored wrong results in different shade of red:

My questions:
1- What should I call that ISO curve? (Starting ISO curve?)
2- Is there any way to get rid of that ISO curve?

Views: 1419

Attachments:

Replies to This Discussion

Permalink Reply by Mohamed Naeim on November 5, 2016 at 2:28am

because its the start and end of the surface

Permalink Reply by Mohamed Naeim on November 5, 2016 at 2:35am

use the inclined interpolate curves to build the surface from loft-straight option 

Permalink Reply by Mohamed Naeim on November 5, 2016 at 2:38am

  see this

Permalink Reply by Mohamed Naeim on November 5, 2016 at 2:39am

file

Attachments:
Permalink Reply by Mohamed Naeim on November 5, 2016 at 3:56am

Update, Complete Solution

You need Anemone Plugin installed

Permalink Reply by Mohamed Naeim on November 5, 2016 at 3:57am

Diamond Pattern 03 

Attachments:
Permalink Reply by Mohamed Naeim on November 5, 2016 at 4:08am

I hope there is no simpler option to do it, I feel exhausted 

Permalink Reply by Mahdiyar on November 5, 2016 at 5:21am

Hi mohamed, Thank you so much.

Permalink Reply by Yoann Mescam (Systemiq) on November 5, 2016 at 8:54am

This could also help.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service