Grasshopper

algorithmic modeling for Rhino

Hello,

Why does the PointOnCrv component from Grasshopper give me a different point than the PointAtNormalizedLength method in C#, even though I used the same curve and parameter?

This was the code I used:

Point3d pt = new Point3d();

pt = crv.PointAtNormalizedLength(t);

A = pt;

Cheers,

Max

Views: 374

Attachments:

Replies to This Discussion

The PointOnCurve slider may actually have additional digits it does not show. I'm not entirely sure. If you zoom in on the PointOnCurve slider and drag it just a little bit, can you move the point without changing the value to 0.61 or 0.63?

Ah, indeed I can, good to know!

Is that a mistake or is there a particular reason?

I can't remember. It sounds like a mistake now.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service