Grasshopper

algorithmic modeling for Rhino

Hello all i am new to grasshopper,

now i am learning grasshopper from Grasshopper Primer by Andrew Payne

in the tutorial i read, i found rectangular grid on the old grasshopper version has P;X;Y;S as input and G;C;M as output

but in my grasshopper the input is P;Sx;Sy;Ex;Ey and Output is only C;P

can You guys help me to solve this problem because in the tutorial told me to use the G output which is Grid as List

Thank You

Views: 3755

Replies to This Discussion

You can use the "P" output on the newer versions of "Rectangular grid" component, instead of "G" on the older component.

thank you so much djordje ,its very helpful !

Hello,

I have one addition question about this same updated version.
In the old version it can create the grids as a center point from 0,0,0 point.
But now in the newer rectangular grid i can only start the corner of the grids from 0,0,0 which pushes center of the grids further.

I tried to deconstruct plane and trying to change the origin with putting values but I think there should be an other thing to do as a default to start the center of the grids from 0,0,0 coordinate but how ?

Hi Bora Doker
If I am correct understand you. You need try to use area centroid component.

Thanks for your reply, It is close but my problem excatly is with matching the z-axis as with the coincident of the central circle that you created.
In my attachment you can see that with the old version of grasshopper gives you what I want as in RED. But your way that is in GREEN snaps -x/-y corner of the grids to begin with from the coordinate 0,0,0.

So I want to put these grids as symetrical either with the x and y axis. The way should also be created by %100 in GH, without any point or line input from rhino commands.

Hope it helps..
Attachments:

Try this variant

 

Thanks for the enlightment mate... Cheers ! :)

I think this is the only solution for these issues. Its a pity that the default is not what I want like in the previous version though.. :/
Attachments:

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service